To MTS-6e ειναι ενα πολυμπριζο AC 220V με 4 schuko (SWD-XXX-e).

Εγγυηση Αντιπροσωπειας χρονια . Δυνατοτητα δοσεων.

Features

• The Dual-Spring vise structure is newly-developed for the contacts of our new outlet, SWD-XXX-E. Due to its strong holding power and 9mm wide contact area, the contacts tightly hold the inserted pins and reduce vibration at the contacts with no loss of signal transmission.
• The main body of the outlet is made of PBT + GF30%, a high density engineering plastic material with both excellent mechanical properties and electrical insulation properties, to increase the braking capacity to the utmost limit.
• The chassis of MTS-6e is made of highly rigid stainless steel which is non-magnetic SUS 304. It protects from not only vibration but also electric-magnetic wave or external noise contamination. And all components, from 1.6mm thick chassis down to every stainless screws, are made of non-magnetic substance.
• For the soldering connection, we employed SS-47 audio grade solder. Compared to general solders which usually contain 3N (99.9%) pure tin, SS-47 contains 4N (99.993%) pure tin achieved by excluding impurities to the maximum. Furthermore, 4.7% silver and 1.7% copper are contained for the purpose of improvement of electric conductivity and durability.
• For the inlet, we use the NC174RR (IEC60320 inlet), which was specially developed for our power strips. The inlets are made of buffed brass and plated with a thick layer of highly conductive pure silver (1.5μ) as a base material, and then finished with three times thicker rhodium plating (0.3μ) and two layers of high quality plating.
• The outer casing is made of heat-resistant reinforced resin mixed with glass powder (30%GF PBT) for the highest quality inlets with high speed and extended sound quality.
• The improvement of the MTS-6e is not limited to the selection of materials; the IEC inlet uses an electromagnetic wave absorber to absorb magnetic noise generated at the contact point and reduce the magnetic distortion caused by the contact.
• We adapted electromagnetic wave absorption tape "MWA-010T" which is used around important internal electric contacts and the inside of the chassis to reduce magnetic distortion around the contacts.
• For its internal wiring for AC mains, we employed 2.0mm 4N OFC copper solid wire. And for its insulator, we employed low-dielectric Polyorefin resin.
• For the ground wire, which is one of the key elements that determine the sound, we used our 3398-14 with a precision conductor "102 SSC" copper wire.
• For the better separation from the floor, we specially employed accurately machined brass spikes. Although it is set to four-point support as default, three point support is also applicable according to your preference.

Specifications

• Model Name MTS-6e
• Chassis 1.6mm thick stainless steel (SUS 304)
• Hookup wire OFC 2.0mm solid wire ( AC mains) / 3398-14 (Ground)
• outlets Original SWD-XXX-E (24K gold + Palladium plating)
• Inlet IEC 60320 C-14 Inlet (NC-174RR)
• Chassis Dimensions W 75 × H 53 × L 460
• Weight 2.7kg
• Rated V/A 250V/10A